Dec 11, 2018  Homedics Total Comfort Ultrasonic Humidifier Warm & Cool Mist. Read the entire manual making sure we didn’t make any mistakes. Tried it again the same night, the entire left tank was all over the dresser and floor. It is soaked! It also like other user said, smells like mold. It's difficult to clean, you can't really clean. Relieve dry air effectively in any room with an ultrasonic humidifier from HoMedics®. We’ve got the best humidifier for your needs, whether you’re looking for a warm mist or cool mist humidifier. Our humidifiers are whisper quiet and feature auto shut-off protection, so you can turn them on while you’re sleeping and wake up feeling. 6- HoMedics UHE-WM65 Humidifier. HoMedics warm and cool mist humidifier with ultrasonic technology is a definite choice to purchase and make the home environment quite comfortable and clean for the family. Its ultrasonic technology whispers calm, observable and micro-fine mist with cool.

• Manual For Homedics Ultrasonic Humidifier
• Homedics Total Comfort Ultrasonic Humidifier
• Homedics Total Comfort Ultrasonic Humidifier Warm & Cool Mist User Manual
• Homedics Cool Mist Humidifier Manual
• Homedics Cool Mist Ultrasonic Humidifier
• Homedics Total Comfort Humidifier Manual

6

7

HEAT

COOL

Cool & Warm Mist Ultrasonic Humidifier

Power Knob
Plug unit in to a 120 volt AC electrical outlet. Push the POWER ON/OFF ( )
button to turn unit on.

ATTENTION: When the water in the tank is almost empty, the power will shut off to
indicate to the user to refill water.

Mist Increase and Decrease
There are 7 different levels of mist output from Lowest to Highest. To increase the
mist output, press the MIST INCREASE ( ) button until the desired mist output is
reached. When the maximum mist output has been reached, the indicator ring light
will blink once and will blink each time the MIST INCREASE button is pressed.
To decrease mist, press the MIST DECREASE ( ) button until the mist has
decreased to the output level desired. When the minimum mist output level has
been reached, the indicator ring light will blink once and will blink each time the MIST
DECREASE button is pressed. (Fig.2)

Warm and Cool Mist Control
The humidifier is equipped with the option to select warm or cool mist. Each time
the unit is turned on it will start producing cool mist. The Warm/Cool mist indicator
ring will glow with a blue light. To select Warm Mist, press the WARM/COOL MIST
button. When warm mist is selected, the mist indicator ring will change from blue
to red and warm mist will start being produced. To return to cool mist, press the
WARM/COOL MIST button again. The mist indicator ring will change from red to
blue. (Fig.2)

How To Use

CAUTION: This appliance has a polarized plug (one blade wider than the
other). To reduce the risk of shock, this plug is intended to fit only one
way in a polarized outlet. If the plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a qualified electrician.
DO NOT attempt to defeat this safety feature. To do so could result in an
electric shock hazard.

HEAT

COOL

Fig.1

Fig.2

Oscillating Head &

Nozzle

Control Panel

Oscillating
ON/OFF Button

Warm/Cool Mist
Indicator Light Ring

Mist Decrease
Button

Mist Increase
Button

Power ON/OFF Button

Warm/Cool Mist Button

Manual For Homedics Ultrasonic Humidifier

10

11

Cleaning and Care

CAUTION: Before cleaning the unit, turn power off and unplug unit from the outlet.

About White Dust

Homedics Total Comfort Ultrasonic Humidifier

Use of high-mineral content hard water will cause a white mineral residue to
accumulate on room surfaces near the humidifier. The mineral residue is commonly
called 'white dust'. The higher the mineral content (the harder your water is), the
greater the potential for white dust. The white dust is not caused by a defect in the
humidifier, but is due only to minerals suspended in the water.

Demineralization Cartridge
The HoMedics demineralization cartridge will help reduce the potential for white
dust, a deposit of minerals left behind from using hard water in your humidifier.
The cartridge should be replaced every 30-40 fillings. The cartridge may need to
be replaced more often when very hard water is used. When the cartridge needs
to be changed, white dust will form around the humidifier. If white residue still
forms around the humidifier after a new cartridge has been inserted, please make
sure that the water you are using is untreated.

If you live in a hard water area,

we recommend the use of distilled water for better results from the
humidifier. Do not use with water softeners.

Installing Instructions
1. Remove demineralization cartridge from packaging and let it soak in water

for 10 minutes.

2. To release the tank from the unit, place your fingers with your palm facing

upward into the recess in the tank handle. Press the tank release button with
your thumb. (Fig.3)

GP21 Circuit Diagram pdf.rar5.1MbPANASONIC ch. Panasonic service manual download. TitleFile SizeDownload LinksPANASONIC 13R18B ch.TMC573 Service Manual.pdf1.5MbPANASONIC 14 TC-2195 TC-21V80 TC-21G10 chassis MX-5 LR3 Circuit Diagram pdf.pdf1.2MbPANASONIC 14LR3 Circuit Diagram pdf.rar304.5kbPANASONIC ch,LA14 TC-32LX34 Service Manual.pdf12.1MbPANASONIC CH.

3.

Place 1 demineralization cartridge down onto post and into the
matching slot in the humidifier base. (Fig.11)

Homedics Total Comfort Ultrasonic Humidifier Warm & Cool Mist User Manual

4. Place the tank back on the base. (Fig.8)
5. Press the tank handle into the base of the humidifier. You will know that the

tank is locked into place when the locking mechanism clicks and the tank
release button is in a raised position. (Fig.9)

Tank Cleaning
Remove the tank from the base by placing
your fingers with your palm facing upward into
the recess in the tank handle. Press the tank
release button with your thumb and lift the
water tank out and away.
Unscrew the tank cap; wipe the tank with a
soft cloth then wash it with clean water.

Suggestion: Clean the water tank once
every two to three weeks, depending on your
water conditions.

Ultrasonic Nebulizer Cleaning
Put small amount of mild dish soap on the
surface of the ultrasonic nebulizer, then pour
in some water and soak for 5 minutes. Brush
clean with soft bristle brush (not included)
and rinse.

Surface Cleaning
Clean the surface of the unit with a clean
damp soft cloth.

Fig.10

Fig.11

Fig.12

Fig.14

Fig.15

Homedics Cool Mist Humidifier Manual

Fig.13

Homedics Cool Mist Ultrasonic Humidifier

Homedics Total Comfort Humidifier Manual